
IOCELL Networks NetDISK User Manual Network Direct Attached Storage / NDAS
2 Cable Installation
2.1 NDAS Mode
Use only one interface at a time.
Your NDAS device may have multiple ports for different data interfaces. Do not connect
the USB or eSATA cable and Ethernet cable at the same time. (USB and eSATA are
single host access protocols. It means that USB and eSATA connections only permit
one computer to use the device when the eSATA or USB wire is connected.
Note: NDAS software does need to be installed on each computer in order to use in
NDAS (Ethernet) mode.
1. If your NDAS device has dip switches on the rear panel, flip both dip switches
down.
2. Connect the included Ethernet cable from the Ethernet port on NDAS device to a
switch.
Wireless users: Connect the NDAS device to your wireless router or access point
with included Ethernet cable.
3. Make sure the power connector is firmly attached to the NDAS device and connect
the power adapter to a power source.
4. If your NDAS device has an On/Off switch, press the On/Off Switch to ON position.
2.2 USB Mode
The USB port takes precedence over the Network port on the 351UNE and 352UN. The
network connection will be terminated if the USB wire is connected to the NDAS Device.
Note: NDAS software does not need to be installed to use in USB mode.
1. If your NDAS device has dip switches on the rear panel, flip both dip switches up.
2. Connect the included USB cable from USB port on the NDAS device to your PC’s
USB port.
3. Make sure the power connector is connected firmly to the NDAS device and
connect the power adapter to a power source. I
4. f your NDAS device has an On/Off switch, press the On/Off Switch to ON
position.
Note: Multiple Disk NDAS device may have special requirements for USB operation if
the drives have been configured in a RAID. Please read the Bind Management
section carefully if you will setup your drives in RAID configurations.
6
Comentarios a estos manuales